|
|
Installation Procedure:
WHAT YOU WILL NEED:
1.Clean Work Area
2. Lint Free Cloth
3. Credit Card
STEP 1:
Clean the screen thoroughly. A microfiber cloth works the best but a regular cloth will work as well.
STEP 2:
Peel the film off its backing, line it ip with your phone and place it on. Then from the middle to the edges slowly squeegee out the air with the credit card making sure to work out any bubbles that appear by pushing them to the edge. Most but not all bubbles and imperfections should be clear within 24-48 hours.
***Bubble Free Installation***
If after 24-48 hours you are unhappy with the results, you can reinstall the protector by first removing the battery in your phone, peeling the protector off the phone and put a small amount of water on its backing with your finger. Then place on your device, slowly and softly squeegee out the water underneath and work out any bubbles that appear, with a cloth soak up any excess water that comes off the edges. As a safety precaution leave the battery out of your phone for 6-12 hours for any excess water to dry.
*You may remove the film and reinstall at any time. However, you generally achieve the best results on the first install. If oil or dirt builds up, you can also clean the protector with soap and water. Oil buildup will cause it to come off. To remove, just peel up on any edge.
*Tips: Do the installation in a clean environment, try to push out each bubble as you lay down the protector.
Print this page
|
|
|
|
